Washer Won T Spin Or Drain

Remove the lid switch you may need to open the washing machine cabinet to access the full switch.

Washer won t spin or drain.

Check the lid switch. Check the water level control if the machine. Sometimes lint or debris can build up in this area and prevent draining. 1 drain pump is clogged.

The second most common item to go bad in your washer is the water level control pressure switch. As a result the washer won t reach adequate spin speeds leaving your clothes dripping wet at the end of the cycle. Perform a master reset this is the first thing a person should try. The lid switch is a safety device designed to shut off the machine if someone lifts the lid.

How to fix a washing machine that won t drain remove the front panel screws. Unplug the washing machine and leave it. Unplug the washing machine and locate the lid switch. You should get a reading of zero which.

Open up the washer. 5 minute zip tie repair of the lid switch gets your washer working again in minutes just need a phillips screw driver and a zip tie visit our website ht. Set the washer in the spin mode and see what happens. If the water won t drain turn the machine off pull the drain hose out of the standpipe and check for a clog at the end of the hose.

How to troubleshoot a washing machine that will not drain or spin the easiest fixes first. This would hinder water flow to and from the. Fix the lid switch if the lid switch has become defective it is necessary to remove it from the machine. If it tripped the machine will stop.

Before you do any work on the inside of the washing machine make sure that the machine is. This is usually always the defective part when your washing machine pumps the water out but will not spin and also when the water overflows on your washer. Undo any kink in the hose. Redistribute the load and run the washer again.

Set your multimeter to rx1 and touch both probes to the switch terminals. There are many possible reasons your washing machine may not be spinning or draining properly. The load is unbalanced. Start by unplugging the machine and emptying the water.

Bail the water out of the tub. Check the circuit breaker that protects the washer. Look for the clog and. It could be due to three possible causes.

If the lid switch is functioning properly go to the next step.