Water Softener Valve Position

These are the inlet and outlet hoses for water moving through the softener.

Water softener valve position.

This article explains how to use repair the water softener or water conditioner system bypass valve. This diy repair guide explains how to replace the rotor position switch in a water softener. Find the valves by following the 2 large hoses running out of the water softener. Locate the water softener then look for 2 large hoses running out of it normally either out of the side or the back.

If the position switch breaks the motor runs constantly. Normally the valves are in a horizontal position when the. To put in a water softener open the water supply valve to the 1 4 position to let oxygen run from the drain line. 7 set the bypass valve to the bypass position and turn on the water to run through the softener for a few minutes to flush out sediment and expel air in the pipes.

Turn the water supply valve completely on when a steady stream of water appears at the drain. Water softener bypass valve operation repair guide. Also open the valves to the water heater and restore its power and or turn the gas valve back on and relight the pilot if necessary see how to relight a gas water heater. Check the valves positions.

The rotor position switch tells the timer what position the rotor is in so the timer knows when to start the motor that turns the valve rotor through cycles. Put your conditioner into the backwash stage and set the bypass valve to the service position. One on the inlet one on the outlet and one on the main line. The bypass valves are located where the water softener connects to the water pipes.

This is usually behind the water softener s control box.